News

BIS retentions review on protecting subcontractor funds triggered by Lords

Story for CM? Get in touch via email: [email protected]

Comments

  1. Retention sums have been a bone of contention for as long as I have been in this industry, 40+years.
    The principle of holding a retention is sound and has proved to be so many times, to correct defective works etc, but it is the abuse of retention sums that is the cause for concern.
    I would suggest the following,
    1. a cap on total retention sums to 2% of the contract value and half released on practical completion or sectional completion of works.
    2. Any company holding retention sums to have an insurance backed guarantee to safeguard these monies.
    The firms not releasing the final sums at the end of defects liability period would be subject to interest charges at base + 4% and /or form part of the insurance guarantee. The above could be operated in the form of a bond via the banks, which would be shown in the company accounts and have a direct effect on borrowing criteria.

  2. Continuity of work is a better incentive than retention.
    If it is a large contract why not use a retention bond instead?

  3. As a QS I totally agree that non payment of retention monies affects both main contractors and sub-contractors, Clients often view retentions as their money rather than just holding it on trust on behalf of others.
    If the Contractor or the Client goes into Administration/Liquidation or Bankruptcy then the subcontractors have little chance of being paid their share of retentions. I agree, and would like to see, the retention fund be backed by Insurance or paid into a separate escrow account that could be accessed and distributed by the Administrator, Liquidator or Trustee in Bankruptcy.
    Reform of Retentions in construction contracts in my opinion is long overdue.

  4. It is ridiculous that this subject has dragged on for so long when the solution is actually very simple. Most construction contracts are let under standard or near standard forms, it would therefore be a simple matter for the issuing bodies to amend their terms to the use of Retention Bonds or Bank Guarantees. If you cannot get one then one is not sufficiently well-funded to take the work on (useful knowledge to the Client or Main Contractor). Most of these contracts are supervised by an Architect or Consultant Engineer, it would be simple to have a process whereby they certified any drawdown from the Bond/Guarantee. If the contractor/subcontractor honours their obligations to remedy any defects, there should be no draw down except for contractors/subcontractors that have gone bust. The price of the bond/bank guarantee goes in the price for all bidders and in the case of Bank guarantees, for good standing customers are usually £200 to £500 to set up and a small fraction of a percent per annum on the value of the guarantee

    David A Roberts

    RCCCL

    [email protected]

Comments are closed.

Latest articles in News